The CTS12 Rip-R-Stripper is designed for removing ceramic tile, hardwood floor and other floor coverings. It acts a tool carrier for electric-powered breakers with ratings between 30 ft-lb and 45 ft-lb of force, including Hilti, Bosch, Makita and Hitachi breakers. The CTS12 allows operation of electric-powered breakers in an upright position for less operator strain. General Equipment Co.; 800-533-0524; www.generalequip.com

The iQ360 14-in. Masonry Chop Saw, formerly the Jack Vac 360, features a built-in dust collection system that runs on the same power source as the saw. The saw weighs only 65 lb and is made of high-impact materials to resist damage. A wide table design allows for easier cutting of large materials. The saw can be used indoors or outdoors. It's Quick-Spin filter allows for easy clean up and recycling. iQ Power Tools; 88-274-7744; www.iqpowertools.com

The 42Z Truck-Mounted Concrete Boom Pump features several improvements over earlier models: an expanded deck and a gross weight under 30 tons, among others. The 42Z pump's pipe system only has 45° and 90° elbows, instead of the 30°, 60° and 90° elbows on earlier models. This simplified design reduces wear on the pipe and the need for maintenance. Subframe bolt connections on the pedestal compensate for torsion from the pump's force. Putzmeister America; 800-884-7210; www.putzmeisteramerica.com

The CS Unitec EMF 150 Wall Slotter is able to cut parallel channels in concrete and masonry up to 13/4-in. wide by 1-3/4in. deep. It has two parallel 6-in. diamond blades that can be quickly adjusted for depth and width. The wall slotter's compact design and parallel grips allow for cutting close to edges. It has an integrated vacuum port for concrete dust collection. It is powered by a 20-amp motor with a no-load speed of 7,500 rpm. The wall slotter is well suited to installing conduit, pipe and wires. CS Unitec; 800-700-5919; www.csunitec.com