The Flo-Check USB Hydraulic System Analyzer allows for the complete testing of hydraulic equipment through a simple computer interface. The system can be used for testing, troubleshooting and diagnosing service issues on any piece of hydraulic equipment, including front-end loaders, cranes and excavators. The sensor unit is able to transmit flow, temperature and pressure data to a computer through its USB port, which then displays and logs it using the included software.Flo-Tech; 800-433-5263; www.flo-tech.com

---

The Airband is a portable, pneumatic band saw that is designed for use in hazardous environments. This includes oil and gas facilities, utilities and other situations where a volatile atmosphere may be present. The Airband can cut a wide variety of metals up to 43⁄4 in., including pipe, conduit, bolts, cable, angle iron, I-beams and structural steel. It features a variable-speed motor which uses 20 cfm at 90 psi. The unit itself weighs only 14 lb. CS Unitec; 800-700-5919; www.csunitec.com

---

The Sigma line of compressors features one-to-one direct-drive technology, with an oversized airend connected directly to the motor. According to the manufacturer, the airflow has lower noise levels while keeping the unit cooler than earlier models. A redesigned separator system allows for low oil carryover. Sigma air compressors are available in versions rated from 25 hp to 450 hp, with flows from 72 cfm to 2003 cfm and at pressures up to 217 psig. Kaeser Compressors; 800-777-7873; www.kaeser.com

---

The VP-Series Vacuum Lifter is a below-the-hook vacuum lifting pad that is intended for handling larger steel plates and individual cut-out discs at weights of up to 19,200 lb. It features a beam with three mount assemblies that can be configured for either a single central pad or two offset pads, which are easily replaceable. Available in electric, air-powered and self-contained mechanical models, it includes built-in alarms and pendant controls. Anver Corporation; 800-654-3500; www.anver.com

---

The Rugby Eliminator-MD is a dumping truck body which is capable of both side and rear dumping. It can be configured with either driver’s or passenger’s-side dumping, and features a fold-down panel on the opposite side for easy forklift loading. Trailers and other rear attachments can remain on the truck during side dumping, saving time. Dumping is operated by a single lever control. The fully boxed perimeter tailgate with vertical side and tailgate bracing helps maintain load stability. Equipment International; 800-869-9162; www.rugbymfg.com