This week we look at a crawler excavator from Hyundai Construction Equipment Americas and a scaffold ratchet from Snap-On Industrial Brands. Click to begin the slide show.
Product Snapshot: Crawler Excavator and Scaffold Ratchet
The Hilti HIT-HY 100 Adhesive Anchoring system can be used for a wide range of anchoring applications. It is ICC-ES approved for use in uncracked concrete. The adhesive is able to cure in 30 minutes at 68�F. It is designed to be used with the existing Hilti dispenser platform, including the HDE 500-A18 battery-powered dispenser and the HDM 500 manual dispenser.
Hilti; www.us.hilti.com
The Williams Scaffold Ratchet sports three tools for assembling and disassembling scaffolding. A ratchet with a 1/2-in. drive pinned to a 7/8-in. six-point socket is for the 7/8-in. hex nuts found on scaffolding. The bronze hammerhead can pound out quick-release levers, while a pry bar aids in scaffolding disassembly. The ratchet has a 36-tooth gear that can work at 10� off-center for easier use in tight areas, and its reversing lever can be used one-handed.
Snap-On Industrial; www.snaponindustrialbrands.com
The Hyundai R330LC-9A HC Crawler Excavator boasts a bucket breakout force of 51,7000 lbf and a maximum digging depth of 24 ft. It is powered by a 268-hp Cummins QSL9 engine that meets Interim Tier 4 emissions standards. The hydraulic system has been improved compared to earlier models, with a redesigned valve control system to improve regeneration when the boom is lowered. An auto-boom-swing function simplifies controls during the lift cycle.
Hyundai Construction Equipment Americas; www.hceamericas.com
The Makita LS1018 Miter Saw has a 10-in. sawblade with a cutting capacity of 12 in. at 90� and 81/2 in. at 45�. It is powered by a 13-amp motor with a soft start to reduce the chance of damaging the motor. The entire miter saw weighs only 43.7 lb, allowing it to be easily transported around the jobsite as needed.
Makita; www.makitatools.com
Post a comment to this article
Report Abusive Comment